X2 low SR blind scanning

[rrob311]

I have noticed this box picks up more channels on a blind scan than my Openbox. I have been picking up some super low SR channels. I just tweaked my 7.5' SAMI a little and was able to pickup a 1360SR and a 1205SR on 55.5w found a couple in the 1600 range too. The dish is still off a bit. I just did a "smart scan" with my pansat 9200 and it didnt pick anything up below 2575SR. My Openbox S10 on accurate scan missed a few of the sub 1600sr transponders. It was able to get about half of them.

[cpr43]

This are the lowers mine have found, really low!!

Satmex 5
AVC TV 3871 V 1110

NSS806
Epoca TV 3889 H 1050

[rrob311]

Carlos were you able to find those with your Openbox or Manhattan ever? I just scanned 40.5 for the 1st time today.

[el bandido]

Are you getting any channels on these low SR transponders?

[cpr43]

Nope!! The Openbox or the Manhattan never see them. The only way they show up is if I add them manually using the editor. the X2 blindscan them automatically. On the other hand I have an Uruguayan S2 TP in Hispasat 30W 11909 V 7200 S98 Q66 which is pretty easy to scan and watch for the Openbox but the X2 has a lot of problems to scan and watch.

[cpr43]

Are you getting any channels on these low SR transponders?

Yes, the X2 scanned them automatically and they can be watch. Some of them take sometime before it pop up. Satmex 5 on 116.7W is the best sat to test low SRs. there are over 10 TPs below SR 2000

[rrob311]

Are you getting any channels on these low SR transponders?

Ya the ones I mentioned all scan in channels. 4095H 1360 is Tropical TV on 55.5. 3722H 1205 is a radio channel. 4100H 1840 also has some radio stations.

[rrob311]

One channel I cannot really view with the X2 that will scan in is FSTV on 123w. The channel comes up but I can't lock video and audio while my Openbox S10 has solid audio and video that locks up some. This has always been a tough channel and my dish is not perfect.

[rrob311]

I reset my motorized Ku dish and was scanning 61w and keep locking a 11858H 0786 transponder. I am not getting any channels from it but it keeps locking it. That is the lowest I have seen.

[rrob311]

I am unable to scan in Gem TV on 91w. It does not blind scan in. It will lock the transponder and then drop out. A manual scan does not get it for me either.

[cpr43]

I am unable to scan in Gem TV on 91w. It does not blind scan in. It will lock the transponder and then drop out. A manual scan does not get it for me either.

Same happens to me, the openbox scan the tp fine but the X2 cant

[rrob311]

I am also unable to get the 16apsk channels on 95W. It tries to lock the signal but keeps dropping out. Possibly a firmware issue because acts the same way as the GemTV channel. 1035 Symbol Rate channels.