Hot Dish 90

[eastof111]

If anyone has an old DMS Intl Hot Dish 90 sitting around, I could sure use some info.

If you have the time, I would appreciate the measurements end to end of the #10 feed support and #11 feed support tube. Thanks.

[Costactc]

I have one lying around in my basement. The pic is a bit sketchy, is it the the throat and lnb holder length that you want?

[eastof111]

Yeah, the bracket (square) that holds the lnb holder and the two circular tubes that hold the lnb bracket.

Thanks...

[Costactc]

In total, just under 5". The first part, before the curve is just under 2" and the upper part where the lnb is held is 3". Damn, I just realised I have 4 mesh panels for a 10' bud, 2 90cm and an 18" dish in my utility room.

[eastof111]

Thanks Costactc...

Don't forget to check the attic, you may find more valuables.. LOL