s10 openbox wont stay on

[hhh1]

When i power on box the front panel shows "boot" then "sept" then cuts out anyone any ideas?

[el bandido]

Welcome to Legit!
What caused the receiver to do this? Did you load a firmware file or a channels list right before getting this error? Have you tried loading a firmware file through the RS232 port for recovery?

[hhh1]

Thanks for your reply. We had a power cut during the night and when i went to turn on the box it was dead, i unplugged it at the mains left it for a couple of mins and now it fails to boot

[cpr43]

Hit the V-format boton a couple of time and wait between each other until you get the video back. If you dont get video then you need to load a factory file using a null cable and your pc com port. Look for the recovery file on the openbox files section

Updated:

Here is a direct link for the files you need to recover the unit

[Only registered and activated users can see links]

[hhh1]

I 've downloaded the file and connect the unit to computer using null cable but computer doesnt recgonise unit

[cpr43]

You need to marked to include bootloader unplug the unit hit the start and then plug the unit back immediatly , you may need to try several times until you find the right timing

[Costactc]

I 've downloaded the file and connect the unit to computer using null cable but computer doesnt recgonise unit

You need to set up the proper port setting so the computer can recognise it.

[Pixl]

If it went dead after a power cut, your power supply may have been damaged. Is there any indication of power such as lights, display etc? Do you have a volt meter or know someone who could do a few voltage checks inside?