View Full Version : Invacom Flange for Offset?
Costactc
10-02-2013, 09:39 AM
Just curious if an invacom twf-031 flange lnbf can be used on an offset dish? I will be installing a 4' offset dish and would like to use my new invacom.
el bandido
10-02-2013, 10:46 AM
You can use it but there will be a noticeable loss in signal.
I use the Raven feedhorn for my 4ft. offset dish. Look in the link.
[Only registered and activated users can see links]
Costactc
10-02-2013, 11:41 AM
Thanks for the reply EB but it would be much cheaper if I just picked up an invacom snh-031, I can add the twf-031 as a side feed on one of the 2 big boys.
el bandido
10-02-2013, 12:39 PM
The snh-031 should work well for you. You might notice a db or two difference between it and the Raven setup, which would be fine for about 98% of the signals up there. EB
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.