Save Database

[norman881]

My Openbox X5 has FW dated Feb 2014. After setting everything up, I'm trying to save my settings to a USB drive. When I access the page for doing this, the last option is Load/save. When I click on the option the only choice is to load a DB to the box. (No option to save)

The X5 manual shows Load and Save on 2 separate lines. My screen only shows one.

Am I missing something?

Thanks

[cpr43]

You need to have the USB inserted in the box before accessing the Edit Channels section. When you go to the Load/Save DB area you need to hit OK over the /udska1 directory you will see immediatly the Save DB blue boton in the right lower corner.

Note:
USB should be formatted as FAT32

[norman881]

Thank you very much Carlos! I was too busy looking at the "Load By USB" at the top of the screen and did not see the "Save" at the bottom. :)