Openbox Question

[GI_Joe]

Where are the SAT positions stored in the Openbox? By this I mean the DISeqC settings that are used to control the stored location of each satellite that gets sent to the motor.

Something tells me that they are stored in the TP_Prog file, but I'm not sure.

[el bandido]

I think you are correct. 8)
You can change or set the stored satellite position using the channel editor program.

[GI_Joe]

Thanks EL.

I never really though about this until a few days ago when I upgraded (and then downgraded) the firmware in one of my openbox receivers.

I decided I liked the previous version of firmware better, so I loaded it back in. Green tint was not an issue so I went back.

Thanks,

[ViP3R]

Thanks EL.

I never really though about this until a few days ago when I upgraded (and then downgraded) the firmware in one of my openbox receivers.

I decided I liked the previous version of firmware better, so I loaded it back in. Green tint was not an issue so I went back.

Thanks,


I went back as well, I find the previous file scans a little quicker.