View Full Version : VonWeise 24 inch actuator
Terryl
07-11-2016, 12:10 PM
Anyone have a parts layout diagram for a 24 inch VonWeise actuator?
Mine went FUBAR and I need to see what I am up against if I try and repair it my self, 200 smackers for a new one is a bit outside my budget right now.
But replacing the limit switch actuators (they fell apart) and the micro switch is not.
Costactc
07-11-2016, 12:34 PM
Although I am using 2 VonWeisse jacks at the moment I do not have any specs on them at all.
Terryl
07-11-2016, 01:07 PM
Darn...And I can't fine any listed on-line ether.
I sent an E-mail to the company to see what they have.
ViP3R
07-11-2016, 01:31 PM
I grabbed this off the net..hope it helps.
13172
Terryl
07-11-2016, 01:42 PM
Thanks, I have seen that one, I think mine is an earlier model as my limit switch cams do not have the two set screws as shown in that drawing.
And the internal lay out is a bit different, I will try to go take a photo, that may help.
ViP3R
07-11-2016, 01:46 PM
Thanks, I have seen that one, I think mine is an earlier model as my limit switch cams do not have the two set screws as shown in that drawing.
And the internal lay out is a bit different, I will try to go take a photo, that may help.
I see.. bummer, well hopefully VonWeisse will send you something, they seem a pretty good company.
Terryl
07-11-2016, 02:03 PM
Here are a few photos.
13173
13174
13175
The last one shows the cam that has the center part crumbling apart.
But it's for the East/West limit switches, the problem I think may be the little square black item in the top photo, that may be the sensor I need.
Terryl
07-11-2016, 02:09 PM
This is the little black square thingy that may be the sensor that is FUBAR.
13176
Powered by vBulletin® Version 4.2.2 Copyright © 2024 vBulletin Solutions, Inc. All rights reserved.