S12 File

[Bellboy]

Just got my S12 what file do U recommend loading Is it this one below?

[Only registered and activated users can see links]

[el bandido]

That would be a good file to start with.
BTW, Does the display work? What color did they send?

[Bellboy]

That would be a good file to start with.
BTW, Does the display work? What color did they send?

They sent Black. Have not hooked it up yet. Going to use that file & will post back. Thanks EB

[Bellboy]

There is a little door on the right side of the unit what is that for? Can U hook up RCA jacks instead of HDMI?

[el bandido]

Mine does not have a door that I have seen, but it does have a card slot on the side.
They should have sent you a cable for connecting the RCA jacks. Look in the box. It should be there.

[Bellboy]

Mine does not have a door that I have seen, but it does have a card slot on the side.
They should have sent you a cable for connecting the RCA jacks. Look in the box. It should be there.


Got it so far display works. I didn't add the new file yet.

[el bandido]

A seventy dollar receiver, shipped here in 7 days...lol

[Bellboy]

A seventy dollar receiver, shipped here in 7 days...lol

Great service Bro. They said at first I wouldn't get it until the end of the month. LOL

[el bandido]

One thing to remember: The USB port on the back of the receiver is located very close to the heatsink for the main chip. This allows the tip of the USB stick to get hot-around 130 degrees hot if you leave the USB connected for several hours. This has not hurt any of my USB drives or devices but you may want to get an USB extension cord and plug it into the receiver. Doing this will keep your USB drive cooler and it will also prevent you from removing an USB drive with a hot tip!!! EB

[el bandido]

There is a little door on the right side of the unit what is that for? Can U hook up RCA jacks instead of HDMI?

OK. I looked at my receiver and that "Door" does absolutely nothing. It is covering up a hole in the side of the receiver. This hole was made at the factory for an additional piece of hardware. Do not mess with this door or you will have a hole in the side of your receiver. EB

[Bellboy]

Load file no problem hooked up & set doing a scan. Display is workiing as it is scaning.

[Bellboy]

Load file no problem hooked up & set doing a scan. Display is workiing as it is scaning.

Just finished scanning 83W got 14 channels. Got it on channel 4 & display shows channel 4.