el bandido
04-27-2012, 08:42 AM
Attached is a file that will allow the firmware to be loaded through the RS232 port on the receiver.
This loader program has been tested by me. It takes between 45 minutes and 1 hour to transfer and load a file on the Raptor using the RS232 port.
The attached loader program has a list of instructions on the face of the loader, and it auto detects your computer's serial port. This is a big improvement over the RS232 loaders that we have had in the past.
This loader program is not recommended for normal firmware transfers due to its slow speed. It is suggested to use the receiver's USB port for normal file transfers.
The suggested use for this loader is for receiver recovery ONLY! EB
This loader program has been tested by me. It takes between 45 minutes and 1 hour to transfer and load a file on the Raptor using the RS232 port.
The attached loader program has a list of instructions on the face of the loader, and it auto detects your computer's serial port. This is a big improvement over the RS232 loaders that we have had in the past.
This loader program is not recommended for normal firmware transfers due to its slow speed. It is suggested to use the receiver's USB port for normal file transfers.
The suggested use for this loader is for receiver recovery ONLY! EB