I am having the same scan problems as everyone else & I'm not using any switches.
Printable View
I am having the same scan problems as everyone else & I'm not using any switches.
No switches on my end either. Turns out to be about 1 reboot per 5 blind scans and hopefully blind scan speed can be addressed as well.
This is very odd to me.. when I set up the Anaconda, I scanned my C-Band arc from 55W to 123W through the whole day non stop.. not one single reboot needed and all scans completed... Go figure!Quote:
Originally Posted by Costactc [Only registered and activated users can see links. Click Here To Register...]
Perhaps it only occurs when scanning KU band.Quote:
Originally Posted by ViP3R [Only registered and activated users can see links. Click Here To Register...]
I can't see it only occurring when scanning on ku band. I initially set my anaconda up on c band and scanned all sats- don't recall having this issue. My receiver is set up on my ku feed and it happens on a daily basis. My ku blind scans are always 11700-12200 unless scanning a sat with lower frequencies and c band was 3600 or 3700-4200 depending on the sat.
Am I the only one using the Anaconda on C-Band ? Costa said he did not see this when on C-Band and he does now on KU, I will hook up the Anaconda tomorrow on my KU and see if I get the same.. Thanks all for your input.Quote:
Originally Posted by SatelliteGuy [Only registered and activated users can see links. Click Here To Register...]
Actually, I'm going to hook up my anaconda on c band right now and check it out.
I am scanning Amc6 at the moment on c band with my anaconda. I had forgotten that default when you go manual in the blind scan menu was 3700-4200, just wondering if its an issue because you actually have to change the numbers for ku band.
3700 and 4200 are not default scan parameters. They are only numbers that appear when you select manual mode.
In automatic mode, the entire range is scanned from about 950 MHz to 2150 Mhz.
To find out what is being scanned in automatic mode, subtract 950 from 5150 for your high limit and 2150 from 5150 for your low limit. EB
Did it again EB. I meant default when you choose the manual option. So far I haven't encountered any issues on c band at all and I have changed the frequency several times. I'm thinking that when you input 11700-12200 for ku and the scan starts at 27.9% that it just jumps but I can't explain it.