TNAP-3 Test Images for OSMIO4K - Discussion

Quote:

---

Originally Posted by el bandido [Only registered and activated users can see links. Click Here To Register...]

OK
We need to find out why one 5G connects and the other does not?
Are both of these 5G routers open or password protected?

---

Mine has a password.

Shown below is the drivers page that can be found in downloadable plugins.

[Only registered and activated users can see links. Click Here To Register...]

My Mio4k is connected to 5G with a password and the Haupauge 850 is working fine with drivers installed. EB was nice enough to send me the image with drivers installed.

I have tried several times. I am able to connect at 2.4 fine, but not 5G on TNAP-3. I checked TNAP-1 and it still connects at 5G. All of my networks are password protected.

No new plugins found. I was not connected to the Internet after my 5G attempts failed. I reconnected at 2.4G and can now download the drivers for my 955Q.

Thanks!
Norman

You will get the no new plugins message if there is no internet connection. You will need to refresh the plugins list once internet is restored, or you will get this message again.
[Only registered and activated users can see links. Click Here To Register...]

If you are certain you have an internet connection, then run software update. Running a software update should refresh the downloadable plugins list, providing the receiver is connected to the internet.
[Only registered and activated users can see links. Click Here To Register...]

This is what the downloadable plugins list should look like if the internet connection is working, and if the plugin list has been refreshed.
[Only registered and activated users can see links. Click Here To Register...]

[Only registered and activated users can see links. Click Here To Register...]

The check internet connection step in setup shown above is broken. I have spent a lot of time in this area in past versions, and it will probably be best for now to skip this step entirely in setup.
This is what would happen if this setup step is deleted:
If a working Ethernet cable is connected to the receiver, then internet will automatically be available for the receiver.
If a wireless internet connection is to be used, then it would need to be setup AFTER the initial setup is completed.

Quote:

---

Originally Posted by el bandido [Only registered and activated users can see links. Click Here To Register...]

[Only registered and activated users can see links. Click Here To Register...]

The check internet connection step in setup shown above is broken. I have spent a lot of time in this area in past versions, and it will probably be best for now to skip this step entirely in setup.
This is what would happen if this setup step is deleted:
If a working Ethernet cable is connected to the receiver, then internet will automatically be available for the receiver.
If a wireless internet connection is to be used, then it would need to be setup AFTER the initial setup is completed.

---

I have connection problems that are "partially" working. I'm going to start from scratch and do a clean install on Saturday. I'll keep reading here all week.

Thanks for the update!
We need to figure out what is going on as the wireless connection should not work for some, but work for others. I also plan to have an updated image version available in the next few days. The updated image version should have ATSC drivers loaded bt default, plus a few other things.

Quote:

---

Originally Posted by el bandido [Only registered and activated users can see links. Click Here To Register...]

Thanks for the update!
We need to figure out what is going on as the wireless connection should not work for some, but work for others. I also plan to have an updated image version available in the next few days. The updated image version should have ATSC drivers loaded bt default, plus a few other things.

---

You are welcome. I noticed last night that even though I could use OpenWebIF at 2.4Ghz only that when I did a network test, the IP test fails while I am connected. (??) Time to start over. My entire system is Ubuntu Linux and wireless only.