If anyone has an old DMS Intl Hot Dish 90 sitting around, I could sure use some info.
If you have the time, I would appreciate the measurements end to end of the #10 feed support and #11 feed support tube. Thanks.
Printable View
If anyone has an old DMS Intl Hot Dish 90 sitting around, I could sure use some info.
If you have the time, I would appreciate the measurements end to end of the #10 feed support and #11 feed support tube. Thanks.
I have one lying around in my basement. The pic is a bit sketchy, is it the the throat and lnb holder length that you want?
Yeah, the bracket (square) that holds the lnb holder and the two circular tubes that hold the lnb bracket.
Thanks...
In total, just under 5". The first part, before the curve is just under 2" and the upper part where the lnb is held is 3". Damn, I just realised I have 4 mesh panels for a 10' bud, 2 90cm and an 18" dish in my utility room.
Thanks Costactc...
Don't forget to check the attic, you may find more valuables.. LOL