I flashed the latest file as ALL CODE on my x2 III and I bricked it. The display only shows ON and will not connect at all. Any way of unbricking it?
Printable View
I flashed the latest file as ALL CODE on my x2 III and I bricked it. The display only shows ON and will not connect at all. Any way of unbricking it?
Same like my X2 premium .Its stay "ON'. ,and nothing on the tv/ black screen/ , The lighting hit it ..
Both do have recovery package using RS232 Null Cable and Com port on your computer. I have sucefully recovered both using these method.
Premium III
[Only registered and activated users can see links. Click Here To Register...]
Premium II
[Only registered and activated users can see links. Click Here To Register...]
I didn't check them ,but I guess my 4x1 switch and the LNB are blown up also . I did had the same problem back in the years . .
Thanks Carlos, I will give it a shot. I haven't flashed a file this way in at least 8 years. I do have cables but not quite sure which is null modem and I would have to start up my extremely old laptop which has the 9 pin port to accomodate the cable.
Most RS232 cables provided inside FTA boxes are Null. Straight cable is rare and use in limited models. So if your came inside of any model most be Null. Once you set your Com computer its a pretty easy process to do. Good Luck!
I used to do this very often but I haven't in many years. I will power up my old dinosaur laptop later and attempt a recovery.
It took several attempts to realise I wasn't using the right cable, finally got it to take. My x2 Premium III is back in service, pic of Rtvge on Telstar 12:
[Only registered and activated users can see links. Click Here To Register...]
Unbelievable....I did a fw upgrade via the internet and it's bricked again. The tv screen says Strong, not Premium III. I am going to transfer the latest file via null modem cable and hope to bring this stb back to life again.:wtf:
Something is happening lately with X2 though!