Has the loader been configured for Com Port 5?
You may also change the com port from 5 to 1 in the device manager of the computer. Normally, it will not hurt anything to do that, but it would depend on what has been assigned com port 1.
Printable View
Has the loader been configured for Com Port 5?
You may also change the com port from 5 to 1 in the device manager of the computer. Normally, it will not hurt anything to do that, but it would depend on what has been assigned com port 1.
EB Thanks, I changed to com port 1 in Device Manager and still getting the same. Thanks I think this receiver has had it!
Have you contacted X2 to see is there is any warranty open?? How old is this receiver?? Have you try to recover using an old file from our files section different from the one marked as Recovery file in the loader rar file?? Maybe it will accept an older file.
It may be a good idea to test the rs232 serial connection on another receiver that works to verify that your computer is communicating with the receiver.
You will get these messages when the loader is connected to the computer, but not connected to the receiver. You need to have a Good, Null rs232 cable Connected to the back of the receiver and to the USB serial adapter.Quote:
Originally Posted by jdelanos73 [Only registered and activated users can see links. Click Here To Register...]
jdelanos73, I Bricked mine a couple of months ago. The cable I used was a 9 to 9 RS232. Pin out 2------3, 3-------2, 5--------5. And the shields were connected at each end. I think your better off to use a computer that has a 9 pin serial port rather than trying to use a usb adapter,If that's what your doing . I have found that sometimes those adapter don't work well with some things. Good luck.
+1
Always better to use a dedicated serial port..... usb adapters do work BUT only if you are lucky to find the correct hardware compatibility.
A serial port on a computer today is very rare. Most computers made within the last ten years do not have them.
I want to thank everyone for trying to help me. I tried doing what everyone suggested in above posts. I will look for a receipt to send it back to factory. Thanks
Please let us know how it works out.....