i got the Vu+solo out yesterday to check it out and up grade the firmware it had a old version oh blackhole on it. I flashed OpenPli on and now all i have is a black screen with Hdmi i tried a composite cable and get the same thing.
Thread: Vu+Solo Problem
Results 1 to 10 of 10
-
Vu+Solo Problem – 07-11-2015,06:08 AM
-
07-11-2015,06:37 AM
From what i have been reading this may be a clone cannot find a sure way to tell. This is a picture inside of mind
-
07-11-2015,08:30 AM
Video setting may need to be changed, I do that using openweb from my laptop.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assrrob311 thanked for this post
-
07-11-2015,08:40 AM
Where is the file that you loaded??
Try connecting to the box using FileZilla or the web interface.
-
07-11-2015,01:53 PM
i have never set it up on WiFi yet. the file is from openPli forum For the solo.
-
07-11-2015,06:35 PM
Try A different Image and see if it comes up.
Regards.
Chewie
-
07-12-2015,05:34 AM
Yes i tried 4 are 5 images then i noticed a sticker on the bottom of the box that said only use firmware from this site vuplushd.tv i downloaded OpenVix from there it loaded and came up
but my wifi adapter will not work with it
-
07-12-2015,07:19 AM
looks like this is definitely a clone i found another wifi adapter and got it to working but when i load a sat list i get the black screen again.
-
07-12-2015,09:20 AM
I do not normally buy clone receivers, so I cannot help you with this. Clones may have many different problems or issues. try to find an image that will work with it and do not change it.
-
07-12-2015,09:57 AM
I got it to working it finally took my sat file but this is a old version of Vix 2.4.158 came out in 02/2013
-
Post Thanks / Like - 0 Thanks, 1 Likes, 0 Kiss My Assrrob311 liked this post