Not sure if a previous post was deleted. Need Help.
Just got a SL1PLL LNBF Standard Linear.
OpenATV 6.3 on my Mio has no selection for Standard Linear in the LNB selection list.
I'll list what is there:
Under LOF....
C-Band
User Defined
KA-SAT
Circular LNB
Unicable / JESS
Universal LNB
I'm guessing use either User Defined or Circular. Could someone help and let me know if Circular will work or what to plug in for User Defined?
Simple setup. Just need to get the LNBF configured so I can use the receiver to get a signal and peak it.
Greatly appreciate any help.
Results 1 to 3 of 3
-
Geosat pro SL1PLL Correct Settings in OpenATV 6.3 – 04-01-2020,10:22 PM
-
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssArloG thanked for this post
-
04-02-2020,01:32 AM
Thanks El.
Read your guide. Fragmented it would be easy to digest.
I've been utilizing the power of Google all day to find an answer to make life easier.
Hypermegasat only has email now. OpenATV forum where I asked the same question has been stagnant.
TNAP hasn't been on my receiver since new but did dl the latest version this evening.
Unlike with the Titanium c band lnbf that took me about an hour to put up and peak...maybe a little more. This has been a real bear to figure out.
If only positive that the settings were correct so hunting for any signal wouldn't leave me wondering.
Nice write up dude.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assel bandido thanked for this post