Results 11 to 20 of 72
-
02-23-2020,09:47 AM
-
Post Thanks / Like - 3 Thanks, 1 Likes, 0 Kiss My Assnorman881 liked this post
-
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 Kiss My Ass
-
02-23-2020,10:39 AM
My Mio4k is connected to 5G with a password and the Haupauge 850 is working fine with drivers installed. EB was nice enough to send me the image with drivers installed.
click click b00m
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 Kiss My Assel bandido, Titanium thanked for this post
-
02-23-2020,11:17 AM
I have tried several times. I am able to connect at 2.4 fine, but not 5G on TNAP-3. I checked TNAP-1 and it still connects at 5G. All of my networks are password protected.
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 Kiss My Ass
-
02-23-2020,11:24 AM
No new plugins found. I was not connected to the Internet after my 5G attempts failed. I reconnected at 2.4G and can now download the drivers for my 955Q.
Thanks!
NormanLast edited by norman881; 02-23-2020 at 11:49 AM. Reason: New information
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssTitanium thanked for this post
-
02-23-2020,12:04 PM
You will get the no new plugins message if there is no internet connection. You will need to refresh the plugins list once internet is restored, or you will get this message again.
[Only registered and activated users can see links. ]
If you are certain you have an internet connection, then run software update. Running a software update should refresh the downloadable plugins list, providing the receiver is connected to the internet.
[Only registered and activated users can see links. ]
This is what the downloadable plugins list should look like if the internet connection is working, and if the plugin list has been refreshed.
[Only registered and activated users can see links. ]
-
Post Thanks / Like - 3 Thanks, 1 Likes, 0 Kiss My Ass
-
02-23-2020,07:00 PM
[Only registered and activated users can see links. ]
The check internet connection step in setup shown above is broken. I have spent a lot of time in this area in past versions, and it will probably be best for now to skip this step entirely in setup.
This is what would happen if this setup step is deleted:
If a working Ethernet cable is connected to the receiver, then internet will automatically be available for the receiver.
If a wireless internet connection is to be used, then it would need to be setup AFTER the initial setup is completed.
-
Post Thanks / Like - 4 Thanks, 0 Likes, 0 Kiss My Ass
-
-
Post Thanks / Like - 3 Thanks, 1 Likes, 0 Kiss My AssMikeB liked this post
-
02-24-2020,09:34 AM
Thanks for the update!
We need to figure out what is going on as the wireless connection should not work for some, but work for others. I also plan to have an updated image version available in the next few days. The updated image version should have ATSC drivers loaded bt default, plus a few other things.
-
Post Thanks / Like - 5 Thanks, 1 Likes, 0 Kiss My Ass
-
-
Post Thanks / Like - 3 Thanks, 1 Likes, 0 Kiss My Assel bandido liked this post