TNAP-3 Images for OSMIO4K - 20200305 - Discussion

[stephan94]

Hello ,
yes;
when TNAP 3.2 is installed "NO-T2MI" is the default value

[el bandido]

Correct.
T2MI drivers cause problems with some transponders that are 2 - 4 MHz apart. So No-T2MI drivers are default because of this.

[stephan94]

the MIO4K edition (TNAP 3.2)
despite a signal just above the link margin ( 4.8 dB), succeeded
to find and lock a 4K Test (Intelsat39 62 ° East)

[eelstrebor]

Hmm, what has changed? I can't set my timezone. No North American time zones are showing up.

[el bandido]

What timezone are you in, and which image are you using?

[eelstrebor]

What timezone are you in, and which image are you using?

Mountain. TNAP3.2 last time I checked. The splash screen shows 3.0 though.

[el bandido]

The about page will show the image information (Menu--->About). Splash screens mean nothing.

Mountain time setting for 3.2 image is shown below.
[Only registered and activated users can see links. ]

[stephan94]

I don't know if this is possible in the USA,
but here in europe we can set the time with NTP
and I see that for America it exists.

[Only registered and activated users can see links. ]

TNAP3.2 skin AeonFHD_MOD setup/system/systemTime

[eelstrebor]

Strange. I noticed that the mio had the correct time and when I went into the timezone settings it showed Denver. Yesterday it was Amsterdam and when I scrolled through the time zones there weren't any US time zones. But today there are. Go figure.

[Only registered and activated users can see links. ]

[eelstrebor]

I don't know if this is possible in the USA,
but here in europe we can set the time with NTP
and I see that for America it exists.


TNAP3.2 skin AeonFHD_MOD setup/system/systemTime

I'm using NTP.