Sorry if this is in the wrong sub-forum. I've got an Edision Mio and a new 39" dish and a standard LNB that came with it. Specs on the box are:

Model: GT111S
Input: 11.70 - 12.75 GHz
Output: 950-2000 MHz
LO: 10.750 GHz

So in TNAP for Type of LNB/Device can I just choose KU STD 10750 or do I need to use a user defined setting? I ask because I'm getting nothing on the signal finder. I'm trying to get 97W. Used dishpointer to get the azimuth. I have a good compass with the declination set but I've tried both bearings given at dishpointer.com with no luck. I have one of those el-cheapo signal meters and I can get it to "scream" when I move the dish a bit to the right of where dishpointer says to aim, but I get nada in the signal finder in TNAP. In the signal finder I have it set on the 97W sat and pre-defined transponders. Scrolled through them all. I've even set up all the KU sats from 93W to 117W and same. So I think I've got the LNB settings wrong.

Cheers,
Doug