Sorry if this is in the wrong sub-forum. I've got an Edision Mio and a new 39" dish and a standard LNB that came with it. Specs on the box are:
Model: GT111S
Input: 11.70 - 12.75 GHz
Output: 950-2000 MHz
LO: 10.750 GHz
So in TNAP for Type of LNB/Device can I just choose KU STD 10750 or do I need to use a user defined setting? I ask because I'm getting nothing on the signal finder. I'm trying to get 97W. Used dishpointer to get the azimuth. I have a good compass with the declination set but I've tried both bearings given at dishpointer.com with no luck. I have one of those el-cheapo signal meters and I can get it to "scream" when I move the dish a bit to the right of where dishpointer says to aim, but I get nada in the signal finder in TNAP. In the signal finder I have it set on the 97W sat and pre-defined transponders. Scrolled through them all. I've even set up all the KU sats from 93W to 117W and same. So I think I've got the LNB settings wrong.
Cheers,
Doug
Thread: Tuner settings for my LNBF
Results 1 to 10 of 26
Threaded View
-
Tuner settings for my LNBF – 07-24-2020,02:13 PM
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssMegatron817 thanked for this post