Hauppauge Tuner Stops working after latest download

[Timewave]

Hauppauge tuner stopped working after downloading the latest software update.
Did a restore to previous version using the plugin backup and restore.

ATSC tuner C starting working again.

[el bandido]

What is the latest software update????
Numbers are needed instead of saying you have installed the "latest"
Please provide the Build date and Last update information that is shown on the About page (Menu--->About)
ATSC Hauppauge Tuner Drivers are installed in the image, so they should not quit working unless the update was botched or unsuccessful. Providing the dates mentioned above in the backup image you reverted back to may also help solve this mystery.

[voomvoom]

I did this software udate a couple of hours ago, and lost my hauppauge 955q tuner. I have the TNAP 4.0 image on boot one. The kernal went from 5.9.0 to 5.12.0.
I've experienced this kind of problem in the past (from different images) and have been able to remove the hauppauge driver, then re-install the hauppauge driver,
and then do a reboot and have been able to recover the tuner? That method is not working this time?
I've checked my other three images, boot two = openpli, boot three = openspa, and boot four = openvision.
boot two, I had lost the hauppauge tuner, but was able to remove the driver and re-install the driver, then reboot and all is GOOD.
boot three, their was no change, all is GOOD.
boot four, same as boot two, I had lost the hauppauge tuner, but was able to remove the driver and re-install the driver, then reboot and all is GOOD.
And, I have no reason to believe it would/should have anything to do with, or make any changes to the other images?
you ask for Build date and Last update
Build date = 2020-12-21
Last update = 2020-12-21 (I find this strange since I just updated today?, although it was an software update?)
and some others
Enigma version = 2021-04-24[develop]
Kernal version = 5.12.0[NO T2MI]
DVB driver version = 2021-04-26

This really is not a big deal, as I have the other images I can use for ATSC,
but if it is supposed to work, I should at least do my part to try and get it to work?
I'm fixing to leave the house for a while, when I return, if you don't have a suggestion for a fix,
I will likely do a FLASH of the latest TNAP 4.0 (04-29-2021) onto boot one, as it's currently showing in the Flash folder?
So, I will check out your suggestions, when I return?

Thanks,

Al

EDIT:

I've returned from town, and I found no suggestions...
So, I did a FLASH

results are in: ALL is GOOD...!!!

I noticed on the info page, the difference I see is:
Build date = 2021-04-29
Last update = 2021-04-29

Thanks..!!

[el bandido]

Does the ATSC tuner work now?

That update is tricky because it contains a lot of packages. Flashing the image was correct.

[voomvoom]

Does the ATSC tuner work now?

Yes
Thanks!