I have a quick question about setting the elevation of the motor. The instruction book doesn't really state for sure where the measurement is taken.
I have the alignment at the bottom part where it's is labeled "or here" at any rate what I have is nowhere near close to operating correctly so I am wondering if I have taken the measurement at the wrong point or the elevation scale is totally inaccurate. It's been a bit since I've completed a KU install but this one is giving me fits!
Thanks In Advance!
Regards,
WT
Results 1 to 5 of 5
Threaded View
-
Question Setting Motor Elevation On Stab HH90 Motor – 09-11-2021,11:46 PM
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assel bandido thanked for this post