Thread: Channel Master 84e
Results 21 to 26 of 26
-
-
-
02-09-2019,10:23 PM
Hello East
I received my Black Inverto, I have a question, under the Satellite configuration mode>type of LNB do you have it set for just Universal? this LNB is not picking up the NC mux on 103W Ku, My MK1 picks it with no issues.
Let me know.
Thanks in Advance.
Regards.
Chewie
-
02-10-2019,12:35 AM
What transponder frequency? I think the transponder you are looking for is gone. There have been some changes on 103w Ku.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssViP3R thanked for this post
-
02-10-2019,01:16 AM
Chewie, here are my settings for the Inverto which include 8x1, 4x1 and 22k switches in my ku setup; just disregard my diseqc settings. Just for testing purposes during the initial install, tried different settings to see how E2 and the Inverto handled the blind scan. Note, haven't tried the Inverto on other sats yet, but will do once I order a few more for the other ku dishes.
Universal lnb
1- Tonemode BAND = produces the best blind scan for me.
2- Tonemode ON = created many duplicates compared to #1.
3- Tonemode OFF and Toneburst OFF = less blind scan items compared to #1.
4- Tonemode OFF and Toneburst A = same.
5- Tonemode OFF and Toneburst B = same.
I use the sequence repeat only because I have a long cable run, but most likely not needed by some switch settings.
[Only registered and activated users can see links. ]
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 Kiss My AssViP3R, el bandido thanked for this post
-
02-10-2019,09:53 AM
Hello Guys
Thanks for this information, I been playing with different settings and the best that works for me is:
1- Tonemode BAND = produces the best blind scan for me.
The transponder is 12080H 30000, I try Manual Scan and was not able to find it, but I did noticed that scans just about every thing else as the MK1 lnb with a bit higher signal %, oh well it is what it is.
Regards.
Chewie