Your settings look correct.
Check the satellite file. I do not show any transponders in the satellite file for 133W. The satellite will not scan without a transponder table to scan. Use the satellite editor to check this and add the transponders you want to scan. You may also add the transponders manually and scan them as they are entered.
Thread: Tuner Configuration
Results 11 to 14 of 14
-
04-03-2015,03:41 PM
-
04-03-2015,03:49 PM
Thanks EB, I will do a manual scan and input tp info.
-
04-03-2015,04:32 PM
You can manually add the transponders you want using the satellite editor that is included in the image. Doing it this way will store the transponders in the satellites.xml file that is located in etc/enigma2 in my last Zero backup image. You can keep any transponder or other information that you enter by copying the satellites.xml file and storing it on a computer or hard drive. The satellites.xml file may be used on almost any enigma2 receiver.
-
04-04-2015,05:46 AM
I did a scan of 133w by inputting tp info 3790 H 11936 and it scanned in without any issues. I guess you were right, if there aren't any tp then obviously a manual scan cannot be performed. I will add this tp using the satellite editor, time to scan some sats.