I don't care what type/brand of switch you use, the motor should always be before any type of switch, the starting DC current load on a motor will eventually blow out the input/output on any switch.
Even some receivers can't handle the starting load of some motors, the starting DC current load (amps or milliamps) will be even higher on a 13 volt transponder. (all vertical transponders)(the lower the voltage the higher the current)
It should always be Receiver-Motor-switch-LNB.
Also a good idea is to use coax with a pure copper core, some coax has a copper coated steel center conductor, this type will have a higher DC voltage drop at the far end.
To test the type of center conductor use a magnet on the center conductor, if it sticks it's steel.
Results 1 to 10 of 29
Threaded View
-
02-29-2024,12:34 PM
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assel bandido thanked for this post