USALS to diseqc 1.2 position is a bit tricky and is one area of enigma2 that could be improved.

It is a good idea to have a channel tuned on the satellite you want to work with before doing these steps:
To assign a diseqc 1.2 position, first go into antenna setup and assign the position you want to use. My example will be position 26 for 103w ku as shown below.
[Only registered and activated users can see links. ]

Next, enter the Positioner setup menu as shown below.
[Only registered and activated users can see links. ]

In this example, you see the position 26 is displayed in the Positioner setup fpr 103w ku. to fine-tune a ku motor, change the degrees of the satellite until you get the signal you desire or until the signal peaks.

It is important to remember a couple of things:
(1) The degrees of the satellite must be returned to the original value before the new value can be saved.
(2) To save a new position, Highlight Memory index and press the Green remote button. Follow onscreen instructions.


It should be noted that the Positioner setup menu works a bit different for a ku motor as compared to a c band actuator. C band actuators may be adjusted automatically, but the automatic adjustment feature usually fails on a ku motor.

The Positioner setup menu is assigned to the red remote key in TNAP images. What the remote keys actually do may be changed by the user if desired.