Anyone have a parts layout diagram for a 24 inch VonWeise actuator?
Mine went FUBAR and I need to see what I am up against if I try and repair it my self, 200 smackers for a new one is a bit outside my budget right now.
But replacing the limit switch actuators (they fell apart) and the micro switch is not.
Thread: VonWeise 24 inch actuator
Results 1 to 8 of 8
-
VonWeise 24 inch actuator – 07-11-2016,12:10 PM
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssCostactc thanked for this post
-
07-11-2016,12:34 PM
Although I am using 2 VonWeisse jacks at the moment I do not have any specs on them at all.
-
07-11-2016,01:07 PM
Darn...And I can't fine any listed on-line ether.
I sent an E-mail to the company to see what they have.
-
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssCostactc thanked for this post
-
07-11-2016,01:42 PM
Thanks, I have seen that one, I think mine is an earlier model as my limit switch cams do not have the two set screws as shown in that drawing.
And the internal lay out is a bit different, I will try to go take a photo, that may help.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssViP3R thanked for this post
-
-
07-11-2016,02:03 PM
Here are a few photos.
[Only registered and activated users can see links. ]
[Only registered and activated users can see links. ]
[Only registered and activated users can see links. ]
The last one shows the cam that has the center part crumbling apart.
But it's for the East/West limit switches, the problem I think may be the little square black item in the top photo, that may be the sensor I need.
-