After working flawlessly for over 10 months (still under warranty), today my Receiver A of my Mio+ stopped working. I have measured the output voltage on Receiver A and there is none. I compared to Receiver B which has 13 volts (V transponder) and 19 volts (H transponder).
The way I discovered the problem was that Receiver A stopped moving my USALS motor. Receiver B moves it without issue. I use the motor all the time.
I also have always followed the habit of physically unplugging the Edision from AC power any time I connect or disconnect the dish feedlines.
My question: Is there any chance this could be a software issue that can be rectified? Or is this most certainly a hardware issue that can only be resolved by repairing the hardware?
Results 1 to 8 of 8
Threaded View
-
Edision OS Mio+ Receiver A No Output Voltage – 11-10-2023,04:19 PMEdision OS Mio+ 4K UHD w/TNAP 5.1, GT Media V7S5X sharing 4-foot motorized Fortec offset (150W-82W), Invacom QPH-031 Ku linear/circular LNBF, Titanium C1PLL LNBF. 41-inch Star Choice w/circular LNB: 77W. Shaw 60e elliptical 103W/99W.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assel bandido thanked for this post