When i go to the ip addy it doesn't bring me to webif as with my zero, it brings me to Dreambox WebControl.
Thread: Dreambox 800HD
Results 21 to 30 of 42
-
03-21-2015,10:31 AM
-
-
03-21-2015,10:54 AM
To get to the debug/loader webif you have to switch off the box and then hold down the power button whilst pluging the PSU in.
You will then see on the OLED front display ***stop*** and an IP address underneath it.
When you see that type in the ip address shown on the front display into your pcs web browser. That will allow you to access the webif.
It should look similar to this.
[Only registered and activated users can see links. ]
Xtrend ET9500, 1m Gilbertini Dish with Fracarro 0.1db lnb, 75cm Visiosat BISAT G3a triple lnb dish, EMP Centauri IRS system, Technomate TM5402HD, AB Prismcube Ruby, Evo Xfinity Android, nBox 5800s & Amiko Alien 2
-
03-21-2015,10:56 AM
Thanks for all your help Manic, will give it a shot a bit later and report back.
-
03-21-2015,11:07 AM
Good luck
Its pretty much a doddle with the DM800 in all honesty providing you have the right image. Just double check the image from the link i gave you in the PM is the correct image before proceeding.
Xtrend ET9500, 1m Gilbertini Dish with Fracarro 0.1db lnb, 75cm Visiosat BISAT G3a triple lnb dish, EMP Centauri IRS system, Technomate TM5402HD, AB Prismcube Ruby, Evo Xfinity Android, nBox 5800s & Amiko Alien 2
-
03-21-2015,02:06 PM
It's all good Manic but it took a few attempts until I realised that I needed to unzip the file. My DM800 hd is now running enigma2 with Merlin image. Now, I need to figure out what EB was helping me with with my NA sats.
-
03-21-2015,04:07 PM
Just use Dreambox edit.
From the Options function click on new profile then add your username and password and the Vu+ IP address and make sure you set it as Enigma 2 as pictured below from the options menu. Save it under Vu+
Do the same for the DM800
[Only registered and activated users can see links. ]
Download the settings using the FTP function from the Vu+ onto your pc. You can then edit it as you wish. When thats done, select the profile for the Dreambox then just upload it.
[Only registered and activated users can see links. ]
I only ever do a master from my Gigablue 800HD and then transfer it to all my other Enigma2 boxes.
Xtrend ET9500, 1m Gilbertini Dish with Fracarro 0.1db lnb, 75cm Visiosat BISAT G3a triple lnb dish, EMP Centauri IRS system, Technomate TM5402HD, AB Prismcube Ruby, Evo Xfinity Android, nBox 5800s & Amiko Alien 2
-
03-22-2015,04:44 AM
Thanks once again Manic. This will transfer all my zero settings to the dm800?
-
-