s the epg populating using the epg button? I Am guessing you are not using the latest available updates? There were problems like you mention early on but they seem to have been resolved.
You can also set the receiver to get the time from ATSC. You need to also set an ATSC channel that the receiver goes to when first started if you use ATSC transponder time.
Thread: Satdreamgr and ATSC
Results 11 to 20 of 24
-
11-10-2016,12:47 PM
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My AssViP3R thanked for this post
-
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assel bandido thanked for this post
-
-
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assel bandido thanked for this post
-
11-22-2016,11:02 PM
Updated SDG online today and after the reboot, everything in the Channel Selector listing was N/A. Similar to what was discussed in the OpenPLI lamedb vs. lamedb5 thread.
Had to do a manual scan for atsc and all returned to normal after the scan. Hope they correct this soon.
-
Post Thanks / Like - 1 Thanks, 0 Likes, 0 Kiss My Assel bandido thanked for this post
-
11-22-2016,11:10 PM
Maybe need to tell them about it. I do not think they know about this problem.
-
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 Kiss My Ass
-
11-24-2016,12:02 PM
Seems ok here as well, I did an online update yesterday and no problems this time with the channels being red.
click click b00m
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 Kiss My Assrodder, el bandido thanked for this post
-
11-24-2016,03:29 PM
Same here. Just did an online update and things are back to normal after doing and enigma restart.
-
Post Thanks / Like - 2 Thanks, 0 Likes, 0 Kiss My Assel bandido, ViP3R thanked for this post
-
11-24-2016,03:54 PM
Very Good!
A reminder:
Lots of changes are being made to enigmna2 right now by all of the major groups. Some of these changes will cause unwanted problems or issues, It is a good idea to make regular backups, or at least do a backup of your settings before flashing or doing an online update of the image.