When i power on box the front panel shows "boot" then "sept" then cuts out anyone any ideas?
Thread: s10 openbox wont stay on
Results 1 to 8 of 8
-
s10 openbox wont stay on – 06-03-2013,08:08 AM
-
06-03-2013,08:19 AM
Welcome to Legit!
What caused the receiver to do this? Did you load a firmware file or a channels list right before getting this error? Have you tried loading a firmware file through the RS232 port for recovery?.
.
.
Meine Dreambox One ist ein Stück Scheiße!.
-
06-03-2013,08:35 AM
Thanks for your reply. We had a power cut during the night and when i went to turn on the box it was dead, i unplugged it at the mains left it for a couple of mins and now it fails to boot
-
06-03-2013,08:45 AM
Hit the V-format boton a couple of time and wait between each other until you get the video back. If you dont get video then you need to load a factory file using a null cable and your pc com port. Look for the recovery file on the openbox files section
Updated:
Here is a direct link for the files you need to recover the unit
[Only registered and activated users can see links. ]Last edited by cpr43; 06-03-2013 at 09:40 AM.
X2 Premium III HD, Openbox X5/ S10, Gsky V3/V6, iSmart m100
-
06-03-2013,10:31 AM
I 've downloaded the file and connect the unit to computer using null cable but computer doesnt recgonise unit
-
06-03-2013,11:11 AM
You need to marked to include bootloader unplug the unit hit the start and then plug the unit back immediatly , you may need to try several times until you find the right timing
X2 Premium III HD, Openbox X5/ S10, Gsky V3/V6, iSmart m100
-
-
06-05-2013,10:34 AM
If it went dead after a power cut, your power supply may have been damaged. Is there any indication of power such as lights, display etc? Do you have a volt meter or know someone who could do a few voltage checks inside?