Let me try to clarify a bit.
Set all the satellites up at once. Each satellite has its on page. Configure one satellite, then use the left or right arrows to move to the next satellite. Configure the next satellite and repeat...etc. When finished configuring all satellites, then press the green button or press OK to save and exit.
You may return after saving and exiting at a later time, and add or delete satellites using the same sequence.
Results 21 to 30 of 37
-
04-28-2015,11:29 AM
-
04-28-2015,11:58 AM
Oooh.. Ok. absolutely E2 is other planet..lol
When I am confirming : Yes I want to configurate DBV-S2 tuner I have the oportunity to configurate/change/erase etc etc in all required satellites when I am finished the"green" button is saving all my Changes. If I want to Change something on my configuration I need to start again on configuration Tuner DBV-S2 confirmation.. correct?
thanks
-
04-28-2015,12:11 PM
Correct.
E2 is not bad Once you learn it!
-
05-05-2015,12:25 PM
A bit off topic: Is openvix-Apollo.166-vusolose_usb.zip good for Amiko 8900 ?
Nihil sine Deo !
-
05-05-2015,01:37 PM
vusolose = Vu+ Solo SE.
Vu+ Solo SE images will not work on Amikos unless modified for the receiver..
.
.
Meine Dreambox One ist ein Stück Scheiße!.
-
05-23-2015,11:50 PM
Hello. I have scaned some satellites but I have troubles to scan others
I think that the problem is basically to configurate my switch 4x4 (ON / OFF)
3 satellites on side "ON "works perfectly but My satellites on switch OFF is not detecting the LNB ( no channels)
On my configuration below How I can switch to "OFF" and configurate my switch 4x4
This is my current settings on my "ON" scaned satellite:
Config Mode: Advanced
Satellite: 40.5 W
LNB: LNB1
Priority: Auto
Lof: C band
Voltaje Mode: Polarization
Increased Voltaje: No
Tone Mode: ON
Disecq Mode 1.1
Fast Disecq: No
Tone Burst: None
Disecq 1.0 Comand : None
Disecq 1.1 comand: Input 1
Disecq 1.1 repeat: Three
sequence repeat: No
Another Question: If 2 satellites are going to the same Input command. Not problem If I put the same Input number?
example:
Disecq 1.1 comand: Input 1 (satellite 40.5W switch 4x4 ON)
Disecq 1.1 comand: Input 1 (satellite 58W switch 4x4 OFF)
thanks in advance
-
05-24-2015,08:21 AM
What kind of lnbs do you have connected to the Off side of the switch?
-
-
05-24-2015,11:45 AMConfig Mode: Advanced
Satellite: 40.5 W
LNB: LNB1
-
05-24-2015,03:16 PM
Yes. 8 satellites (kU/C band)..All LNB's Dual Legacy.. Not motorized set up
every LNB (satellite) going to==>> switch 4x4 (0/22khz ON/OFF) going to==>> switch disecq 1.1 going to==>> VU+solo SE HD.
I would how configurate switch 4x4. (ON/OFF)..