"On" flashes continuously

easily confused

easily confused

Legit Super Moderator
Just wondering if anyone has had this problem with their S-9. When I turn on the power the word "On" flashes on the fron of the receiver continuously and doesn't stop. This happened about a year ago and I just left in on and after about 15 minutes the flashing stopped, the receiver booted up and all has been fine since then. Last weekend the flashing "On" reappeared. I left the receiver on for over an hour and nothing changed. Anyone ever seen this happen?
 
Have you try re-loading the firmware using a null cable and your pc?? I have heard a lot of bugs on the Openbox but not this one. Pixl came up with a fix for the No Signal (PTC resetable fuse on the main board) and recently a fix for the constant reboot (8 pin dip SD4844 on the power supply board) when using a motor.
 
EC,

I have seen that a few times on early firmware, I just re-booted once or twice and it cleared it.
I later installed the 7-17-11 FW (the best version in my opinion) never saw the "on" thing again.
What ver are you running?
 
Pixl said:
EC,

I have seen that a few times on early firmware, I just re-booted once or twice and it cleared it.
I later installed the 7-17-11 FW (the best version in my opinion) never saw the "on" thing again.
What ver are you running?
Click to expand...

Not sure and with the receiver unable to boot up, I am not sure how to figure it out.
 
easy c have you ever had to take your box and bring it to the computer and use the 232 null cord as the way to fix the open box as in recovery?
 
Last edited:
Pixl said:
Carlos, the SD4844 fix is for the S-10 only, where the PTC fuse is found in many models.
Thanks for the credit :D
Click to expand...

You're welcome!! I ordered some power supply boards as replacements and 2 of my S9 are using them. They fit perfectly, so just in case if he need to use a S10 P/S board he can look for the SD4844, Thanks for all the help!
 
Back
Top