Optibox Anaconda Question Thread

  • Thread starter Thread starter Guest
  • Start date Start date
The unit came with 3/22 firmware, What firmware should we have on the the units at this time. This is the Optibox Anaconda Question Thread. I'm going to have alot of Questions lol
 
Also I high quality USB flash drive is recommended..Kingston is the recommended brand. If you have gone longer that 10 minutes I would remove the USB flash drive and do a hard boot from the rear switch.

You can try again and make sure that Drive is formatted..but if you still have problems I would get a Kingston stick.
 
Ok I Finally got it to load the only way i can see a picture is with a yellow video cable it is showing 480i im in ntsc mode but every time i try to change it says output not available
 
Do you have the HDMI cable connected along with the yellow cable?
Also, Have you verified the correct file is actually in the receiver? What firmware version does the receiver say you have? Look in Main Menu--->Installation--->System Information. Then read what is across from Application Version.
 
Got everything set up sat's and channels scans in working great i think this is the best receiver i have had in a long time and i have owned about all of them.
 
rodder said:
Got everything set up sat's and channels scans in working great i think this is the best receiver i have had in a long time and i have owned about all of them.
Click to expand...

That's great rodder! I am very happy you are enjoying it. People are missing out on a great STB. quality boxes no doubt!

I think the menu's are awesome..best I have seen! not to mention all the features!

How do you like the picture quality on HD and SD ?
 
Back
Top