Please help Golden Media Hypercube

Sorry about your receiver not working. I haven't done a uboot recovery yet since I haven't had the need to do so. Looking at the stage 7 picture, El Bandido wrote the following after he successfully recovered his Hypercube.

"Here are my notes on uboot recovery:
The 2 pin jumper is located next to the 4 pin connector that runs to the front usb port or to the front of the receiver.
You need a pen drive that has a Known Good Hypercube image of your choice installed on it. You may insert the pen drive into the USB port before or after connecting the jumper. The usb pen drive Must Be installed before the boot bin is transferred!"

If you still can't get your receiver to work, you might list a step by step recovery process you have initiated and their results.

Good luck!
 
Device worked
Traced all the stages
After the success of retrieval device
Enigma2 the word on the screen of the device
On television hypercube
 
I think you are saying you went through the complete uboot recovery process and now all you get is the Hypercube logo on the tv screen. If so, I would redo the recovery process again until the receiver accepts the firmware via the recovery process.

Sometimes the recovery process needs to be repeated a few times before the receiver will respond. This applies to most receivers, not just the Hypercube.
 
Back
Top