updates

D

dpope

I am still fairly new , i have x2premiumIII stab motor hh90 and 3 ft dish. when i manual update from usb it does not reckonize anything what i mean is when i try to update newest firmware it goes through the motions and still does not update. after i can go to update by internet and check , it still showa the old software, evan when i update by internet it shows old software still. it just seems like it is stuck at this point, in fact the positions of the satelite stay the same too, it only remembers a few of them , i have an older motor i swaped them and it does the same thing here also. here is what it reads from internet update current version v1.31B1* newest version v11aug15 like i said i go ahead and start it downloads then reboots and after its all done i can go back and check this and it says the same thing as before, any help or ideas would be greatly appreciated
 
Back
Top